Try Before You Buy

Download a free sample of any of our exam questions and answers

  • 24/7 customer support, Secure shopping site
  • Free One year updates to match real exam scenarios
  • If you failed your exam after buying our products we will refund the full amount back to you.

All Obstacles During 72201T Exam Preparation with 72201T Real Test Questions [Q38-Q55]

Share

All Obstacles During 72201T Exam Preparation with 72201T Real Test Questions

Fully Updated Free Actual Avaya 72201T Exam Questions

NEW QUESTION # 38
How does Avaya Aura Session Manager support fault tolerance and high availability? (Choose two)

  • A. By using a distributed system architecture
  • B. By automatically rerouting traffic to backup servers
  • C. By duplicating SIP messages to multiple destinations
  • D. By maintaining session state information across multiple nodes

Answer: A,D


NEW QUESTION # 39
You notice that the Entity_Link between your Session Manager and Communication Manager is down. From Communication Manager, which two command are used to verify the health of this SIP link? (Choose two.)

  • A. statapp
  • B. Status signaling group
  • C. Status trunk
  • D. List trace station
  • E. Status health

Answer: B,C


NEW QUESTION # 40
A customer states they are having voice quality issues when they make calls over a WAN link.
You would like to see what the Quality of Service is for a call, as the customer makes the call.
Which Avaya Aura Communication Manager (CM) SAT command will display packet loss and jitter for a call in progress?

  • A. list trace station xxxx, where XXXX is the station number.
  • B. list monitor qos
  • C. status station qos xxxx, where XXXX is the station number
  • D. monitor station qos xxxx, where XXXX is the station number

Answer: A


NEW QUESTION # 41
In an Avaya Aura environment, which protocol is primarily used for the signaling of VoIP communications?

  • A. MGCP
  • B. SIP
  • C. SCCP
  • D. H.323

Answer: B


NEW QUESTION # 42
When a 96xx telephone with SIP firmware boots up, it goes through a number of steps.
These steps include:
1. Phone Registration.
2. Download PPM.
3. Obtain IP Address and Utility Server address DHCP Server.
4. Check if firmware upgrade is required and download 46xxsettings.txt file.
5. Send Subscribe (avaya-cm-feature-status) to Avaya Aura Communication Manager (CM) via Avaya Aura Session Manager (SM).
What is the correct sequence of these steps?

  • A. 3,5,1,2,4
  • B. 4,3,1,2,5
  • C. 3,1,5,4,2
  • D. 3,4,1,5,2
  • E. 3,4,2,1,5

Answer: D


NEW QUESTION # 43
Which two statements regarding the core architecture in the Avaya Aura 7 solution are true?
(Choose two.)

  • A. SIP trunks can only be configured on Avaya Aura Session Manager (SM).
  • B. SIP User Agents can register to Avaya Aura Communication Manager (CM) or Avaya Aura Session Manager (SM).
  • C. Avaya Aura Media Server (AAMS) cannot connect to Avaya Aura Communication Manager (CM) without routing via Avaya Aura Session Manager (SM).
  • D. Avaya Aura Media Server (AAMS) connects directly to Avaya Aura Communication Manager (CM) using SIP.
  • E. SIP user Agents register with Avaya Aura Session Manager (SM).

Answer: D,E


NEW QUESTION # 44
What ensures the integrity of signaling in an Avaya Aura Communication Manager environment?

  • A. Media Gateway Control Protocol (MGCP)
  • B. Internet Protocol Security (IPSec)
  • C. Transport Layer Security (TLS)
  • D. Secure Real-time Transport Protocol (SRTP)

Answer: C


NEW QUESTION # 45
You are submitting a package of information to Avaya Support for a case you are raising. The files that you are sending include a trace taken using WireShark.
Which file format will the file be in?

  • A. ws
  • B. rar
  • C. pcap
  • D. jpg

Answer: C


NEW QUESTION # 46
Which trouble-shooting tool can be used to investigate PPM issues?

  • A. SIP tracer_asset log
  • B. list trace station
  • C. traceSM
  • D. list trace tac

Answer: C


NEW QUESTION # 47
In Avaya Aura Communication Manager (CM), what are three valid formats of the list trace command? (Choose three.)

  • A. List trace previous
  • B. List trace 1031711
  • C. List trace tac 701
  • D. List trace ras ip-address 135.60.232.213
  • E. List trace next

Answer: A,C,D


NEW QUESTION # 48
Which three statements about media-processing resources (DSPs) are true? (Choose three.)

  • A. SIP-SIP two-party calls will always use SIP Direct Media if Communication Manager (CM) is configured to do so.
  • B. Two-party calls originated by SIP stations or trunks, and terminated by H.323 trunks, media gateways, or other vendors' H.323 stations, will typically shuffle if CM is configured to do so.
  • C. Two-party calls originated by H.323 stations, trunks, or media gateways, and terminated by SIP stations or trunks, cannot shuffle.
  • D. H.323-H.323 two-party calls will always shuffle to establish a direct media path if CM is configured to do so.
  • E. If a direct media path cannot be established between two IP endpoints the call will fail from release 7.0.

Answer: A,C,D


NEW QUESTION # 49
What information can be found when viewing the Monitoring > Active Sessions page on an Avaya Aura Media Server? (Choose two.)

  • A. Utilized Code
  • B. QOS Analytics
  • C. Caller extension number
  • D. Element status
  • E. Callee extension number

Answer: A,B


NEW QUESTION # 50
Refer to the Exhibit. Which two statements are true about a call from AST 1011111 to AST
1011112? (Choose two.)

  • A. In step 2, Avaya Aura Session Manager (SM) matches 1011111 with a Communication Profile, and uses the defined Originating Application Sequence to route the call to Avaya Aura ?Communication Manager.
  • B. In step 3, Avaya Aura Communication Manager (CM) sends SIP Options to 1011112 looking for a 200 ok response to check it is reachable.
  • C. In step 2, the Avaya Aura Session Manager (SM) uses a dial pattern and routing policy to route the call to Avaya Aura Communication Manager (CM).
  • D. In step 1, when 1011111 draws dial tone it sends an Invite to Avaya Aura Session Manager (SM) with the Request URI containing 1011111.

Answer: A,D


NEW QUESTION # 51
A customer has just added a CS1000 SIP Entity and Entity Link using TLS port 5061. Users are unable to call any Avaya Aura users which are connected via the same Avaya Aura Session Manager (SM). They have run a traceSM and see no SIP messages coming from the CS1000 in the trace. They can ping between the CS1000 and SM100.
Which two traces or logs are most relevant to debugging this problem and should be included in the trouble ticket raised with Tier 3 support? (Choose two.)

  • A. the ppm.log in /var/log/Avaya/jboss/SessionManager on SM
  • B. traceSM with TLS handshaking enabled on SM
  • C. "list trace tac xxx", where xxx is the TAC of the trunk group between Avaya Aura Communication Manager and SM
  • D. the latest /var/log/ecs logfile on Avaya Aura Communication Manager
  • E. "tshark -i eth1 -w <capturefilename>" on SM

Answer: B,E


NEW QUESTION # 52
What is the primary function of the Avaya Session Border Controller for Enterprise (SBCE) in a remote worker configuration?

  • A. To manage QoS policies
  • B. To provide VPN services
  • C. To facilitate NAT traversal
  • D. To encrypt voice packets

Answer: C


NEW QUESTION # 53
A customer has just configured Avaya Aura Media Server (AAMS) on their Avaya Aura Communication Manager (CM). They are saying that the AAMS is never being used by CM, but instead is always using the G450 gateways to provide DSP resources. The customer has checked the status of the Media Server and the Signaling Group and both show In- Service. They have also checked that a Media Server License is installed on WebLM, and the status of the Media Server is showing Element Status as being normal.
Which statement describes the cause of this problem?

  • A. The VoIP Channel License Limit has not been set on the media-server CM SAT screen.
  • B. The Dedicated VoIP Channel Licenses has not been set on the media-server CM SAT screen.
  • C. No trunk-group members have been configured,
  • D. The CM license has no CM Media Server VoIP Channels.

Answer: D


NEW QUESTION # 54
When does Communication Manager insert the shortcut flag during call processing?

  • A. during the dialing analysis phase (imsdialana) of call processing
  • B. during the origination phase (imsorig) of call processing
  • C. during the termination phase (imsterm) of call processing
  • D. during the initialization phase (imsinit) of call processing

Answer: B

Explanation:
A SIP station to SIP station call on a single Feature or Evolution Server uses four signaling legs between CM and SM (not including the initial off-hook imsorig):
1. imsorig
2. origdone
3. imsterm
4. termdone


NEW QUESTION # 55
......

Validate your 72201T Exam Preparation with 72201T Practice Test: https://www.dumptorrent.com/72201T-braindumps-torrent.html

Free 72201T Questions for Avaya 72201T Exam [Apr-2026]: https://drive.google.com/open?id=1dvFPqBbJPnsbOnbwRXgXmUDfGxoti380