Pass JN0-635 Brain Dump Updated Certification Sample Questions

Online JN0-635 Test Brain Dump Question and Test Engine

JN0-635 Exam Process

The Juniper JN0-635 test will continue for 120 minutes. Besides, there are 65 multiple-choice items. You can get to know your pass/fail status immediately after the official test. Once you successfully clear such an exam and obtain your JNCIP-SEC certification, it is valid for three years.

 

NEW QUESTION 43
Click the Exhibit button.

The IKE policy and proposal are configured properly on both devices as shown in the exhibit. Which configuration snippet will complete the IKE configuration on the branch SRX Series device?
A)

B)

C)

D)

• A. Option C
• B. Option B
• C. Option A
• D. Option D

Answer: D

 

NEW QUESTION 44
Click the Exhibit button.

A host is unable to communicate with a webserver. Referring to the exhibit, which statement is correct?

• A. The webserver is not listening for traffic on port 80
• B. A session is created for this flow
• C. The session table is running out of resources
• D. A policy is denying the traffic between these two hosts

Answer: D

 

NEW QUESTION 45
Exhibit.

Referring to the exhibit, which two statements are true? (Choose two.)

• A. The c-1 TSYS cannot use any security flow resources.
• B. The c-1 TSYS has a reservation for the security flow resource.
• C. The c-1 TSYS has no reservation for the security flow resource.
• D. The c-1 TSYS can use security flow resources up to the system maximum.

Answer: A,C

Explanation:
Reference:
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/security-profile-logical-system.html

 

NEW QUESTION 46
You are connecting two remote sites to your corporate headquarters site; you must ensure that all traffic is secured and only uses a single Phase 2 SA for both sites.
In this scenario, which VPN should be used?

• A. A hub-and-spoke IPsec VPN with the corporate firewall acting as the hub device.
• B. Full mesh IPsec VPNs with tunnels between all sites.
• C. A full mesh Layer 3 VPN with the corporate firewall acting as the hub device.
• D. An IPsec group VPN with the corporate firewall acting as the hub device.

Answer: D

Explanation:
Reference:
https://www.juniper.net/us/en/local/pdf/app-notes/3500202-en.pdf

 

NEW QUESTION 47
You are connecting two remote sites to your corporate headquarters site; you must ensure that all traffic is secured and only uses a single Phase 2 SA for both sites.
In this scenario, which VPN should be used?

• A. A hub-and-spoke IPsec VPN with the corporate firewall acting as the hub device.
• B. Full mesh IPsec VPNs with tunnels between all sites.
• C. A full mesh Layer 3 VPN with the corporate firewall acting as the hub device.
• D. An IPsec group VPN with the corporate firewall acting as the hub device.

Answer: D

Explanation:
Explanation
https://www.juniper.net/us/en/local/pdf/app-notes/3500202-en.pdf

 

NEW QUESTION 48
You configured a security policy permitting traffic from the trust zone to the DMZ zone, inserted the new policy at the top of the list, and successfully committed it to the SRX Series device. Upon monitoring, you notice that the hit count does not increase on the newly configured policy.
In this scenario, which two commands would help you to identify the problem? (Choose two.) user@srx> show security zones trust detail

• A. 192.168.10.100/32
  destination-ip 10.10.10.80/32 protocol tcp source-port 5806 destination-port
  443 result-count 10
• B. 192.168.10.100/32
  destination-ip 10.10.10.80/32 protocol tcp source-port 5806 destination-port
  443
  user@srx> show security match-policies from-zone trust to-zone DMZ source-ip
• C. user@srx> show security shadow-policies from zone trust to zone DMZ
• D. user@srx> show security match-policies from-zone trust to-zone DMZ source-ip

Answer: A,D

Explanation:
Explanation/Reference: https://www.juniper.net/documentation/en_US/junos/topics/topic-map/monitoring- troubleshooting-security-policy.html

 

NEW QUESTION 49
Click the Exhibit button.

Referring to the exhibit, which two statements are true? (Choose two.)

• A. The device cannot pass Layer 2 and Layer 3 traffic at the same time
• B. The device can pass Layer 2 and Layer 3 traffic at the same time
• C. You can secure intra-VLAN traffic with a security policy on this device
• D. You can secure inter-VLAN traffic with a security policy on this device

Answer: A,C

 

NEW QUESTION 50
Click the Exhibit button.

When attempting to enroll an SRX Series device to JATP, you receive the error shown in the exhibit. What is the cause of the error?

• A. The SRX Series device certificate does not match the JATP certificate
• B. The fxp0 IP address is not routable
• C. The SRX Series device does not have an IP address assigned to the interface that accesses JATP
• D. A firewall is blocking HTTPS on fxp0

Answer: C

 

NEW QUESTION 51
You must troubleshoot ongoing problems with IPsec tunnels and security policy processing. Your network consists of SRX340s and SRX5600s.
In this scenario, which two statements are true? (Choose two.)

• A. IPsec logs are written to the kmd log file by default
• B. You must enable data plane logging on the SRX5600 devices to generate security policy logs
• C. IKE logs are written to the messages log file by default
• D. You must enable data plane logging on the SRX340 devices to generate security policy logs

Answer: A,B

 

NEW QUESTION 52
You are asked to configure an IPsec VPN between two SRX Series devices that allows for processing of CoS on the intermediate routers.
What will satisfy this requirement?

• A. remote access VPN
• B. policy-based VPN
• C. OpenVPN
• D. route-based VPN

Answer: D

Explanation:
Explanation/Reference: https://www.juniper.net/documentation/en_US/junos/topics/topic-map/secuirty-cos-based-ipsec- vpns.html

 

NEW QUESTION 53
Click the Exhibit button.

Which statement is correct regarding the information show in the exhibit?

• A. The tunnel is not encrypting the traffic
• B. The tunnel binding was discovered automatically
• C. The tunnel gateway address was automatically discovered
• D. The output is for an ADVPN

Answer: C

 

NEW QUESTION 54
You have designed the firewall filter shown in the exhibit to limit SSH control traffic to yours SRX Series device without affecting other traffic.
Which two statement are true in this scenario? (Choose two.)

• A. The filter should be applied as an input filter on the loopback interface.
• B. Applying the filter will achieve the desired result.
• C. The filter should be applied as an output filter on the loopback interface.
• D. Applying the filter will not achieve the desired result.

Answer: A,D

Explanation:
Explanation
https://www.juniper.net/documentation//en_US/junos/topics/concept/firewall-filter-ex-series-evaluation-understa

 

NEW QUESTION 55
Click the Exhibit button.

Given the command output shown in the exhibit, which two statements are true? (Choose two.)

• A. Traffic matching this session has been received since the session was established
• B. Network Address Translation is applied to this session
• C. The host 10.10.101.10 is directly connected to interface ge-0/0/4.0
• D. The host 172.31.15.1 is directly connected to interface ge-0/0/3.0

Answer: A,C

 

NEW QUESTION 56
Click the Exhibit button.

Referring to the exhibit, which three topologies are supported by Policy Enforcer? (Choose three.)

• A. Topology 5
• B. Topology 4
• C. Topology 2
• D. Topology 1
• E. Topology 3

Answer: B,D,E

Explanation:
Explanation/Reference: https://www.juniper.net/documentation/en_US/junos-space17.2/policy-enforcer/topics/concept/ policy-enforcer-deployment-supported-topologies.html

 

NEW QUESTION 57
Click the Exhibit button.

Referring to the exhibit, which two statements are true? (Choose two.)

• A. The JATP Appliance cannot download the security feeds from the GSS servers
• B. The SRX Series device is not enrolled but can communicate with the JATP Appliance
• C. The SRX Series device cannot download the security feeds from the JATP Appliance
• D. The SRX Series device is enrolled and communicating with a JATP Appliance

Answer: B,C

 

NEW QUESTION 58
Click the Exhibit button.

Referring to the exhibit, which three types of traffic would be examined by the IPS policy between Switch-1 and Switch-2? (Choose three.)

• A. UDP
• B. ARP
• C. ICMP
• D. LLDP
• E. TCP

Answer: A,C,E

 

NEW QUESTION 59
Click the Exhibit button.

A user reports trouble when using SSH to a server outside your organization. The traffic traverses an SRX Series device that is performing NAT and applying security policies.
Referring to the exhibit, which configuration will allow you to see the bidirectional flow through the SRX Series device?
A)

B)

C)

D)

• A. Option C
• B. Option B
• C. Option A
• D. Option D

Answer: D

 

NEW QUESTION 60
What are two important function of the Juniper Networks ATP appliance solution? (Choose two.).

• A. Statistics
• B. Detection
• C. Filtration
• D. Analysis

Answer: B,D

Explanation:
Reference:
https://www.juniper.net/us/en/products-services/security/advanced-threat-prevention/

 

NEW QUESTION 61
Click the Exhibit button.

You have two hosts on the same subnet connecting to an SRX340 on interfaces ge-0/0/4 and ge-0/0/5.
However, the two hosts cannot communicate with each other.
Referring to the exhibit, what are two actions that would solve this problem? (Choose two.)

• A. Put the ge-0/0/4 and ge-0/0/5 interfaces in different VLANs
• B. Remove the ge-0/0/4 and ge-0/0/5 interfaces from the L2 security zone
• C. Add an IRB interface to the VLAN
• D. Set the SRX340 to Ethernet switching mode and reboot

Answer: B,D

 

NEW QUESTION 62
......

Real Juniper JN0-635 Exam Dumps with Correct 90 Questions and Answers: https://www.dumptorrent.com/JN0-635-braindumps-torrent.html

Juniper JN0-635 Certification Real 2022 Mock Exam: https://drive.google.com/open?id=16NX09hCrYJjgD1m5l9P5hNrZf5enh-s8