Ultimate Guide to Prepare Free Nutanix NCS-Core Exam Questions and Answer

Pass Nutanix NCS-Core Tests Engine pdf - All Free Dumps

NEW QUESTION 108
An administrator is trying to correct high cluster IOPs and Cluster Controller Latency. Networking is the suspected issue.
Which networking parameters should be configured in the Nutanix cluster?

• A. Number of NICs connected and bond state.
• B. Number of NICs connected and frame size
• C. Bond State and network latency
• D. Number of NICs connected and network latency.

Answer: B

 

NEW QUESTION 109
A customer has engaged a Nutanix consultant to deploy a cluster consisting of two NX-3460-G6 blocks. The consultant arrives at the customer site and fines the following:
* One rack with a total of 5U available
* Two ToR switches with 14 total available ports
* Dual PDUs with six available sockets
What will prevent the consultant from successfully installing the cluster?

• A. Insufficient network ports for communication.
  Rack space may not be continuous.
• B. Insufficient network ports for communication.
  Insufficient sockets for power allocation.
• C. Insufficient rack space for block installation.
  Insufficient sockets for power allocation.
• D. Insufficient sockets for power allocation.
  Rack space may not be continuous.
• E. Insufficient network ports for communication.
  Insufficient sockets for power allocation.

Answer: C

 

NEW QUESTION 110
A consultant is planning an installation and needs to collect configuration items to be used during the install.
The data needed from the customer are IP addresses, Gateway, DNS servers, and NTP Servers.
Which Cluster Deployment document must be completed with the customer?

• A. Questionnaire
• B. Project Plan
• C. Operations Guide
• D. Technical Checklist

Answer: D

 

NEW QUESTION 111
A consultant deploys a four-node VMware ESXi cluster and vCenter server. An HA/DRS cluster is configured for all four nodes. The customer deploys five new VMs on the cluster.
During the knowledge Transfer, a network cable on one node is removed to demonstrate HA and migration of the VMs to another host. In the HA/DRS cluster settings, the VM Restart Priority for all CVMs is set to Disabled. The customer observes warnings that the CVM on the ejected host is no longer powered on.
Which ESXi HA/DRS cluster setting is missing?

• A. Enable Host Monitoring.
• B. Disable Automation Level on all CVMs.
• C. Disable VM Monitoring on all CVMs.
• D. Enable EVC for the cluster.

Answer: B

 

NEW QUESTION 112
An administrator is migrating 5MB shares from a third-party platform to Nutanix Files with the following characteristics:
* Shares contain user profile directories
* DFS-N will be used
How should the administrator create target shares for this migration?

• A. Create standard shares with multiple top-leveldirectories and distribute migrated data.
• B. Create multiple distributed shares and distribute migrated data as evenly as possible.
• C. Create multiple general purpose shares and distribute migrated data as evenly as possible.
• D. Create distributed shares with multiple top-level directories and distribute migrated data.

Answer: D

Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details/?targetId=Files-v3_6:Files-v3_6

 

NEW QUESTION 113
A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected
5-minute interval.
What should the customer do to enable the snapshots to happen at the expected interval?

• A. Utilize Metro Availability to meet this requirement
• B. Configure the protection domain to take snapshots on15-minute intervals
• C. Fix a connectivity issue because the protection domain reverted to Async
• D. Change the protection domain to use Async DR

Answer: C

 

NEW QUESTION 114
A consultant is preparing to add new nodes into an existing cluster. The current cluster AOS version is 5.8.
The new expansion node is currently running AOS 5.9 code. The cluster must continue to run at its current AOS version.
Which method can be used to successfully add the node?

• A. Use the CLI and enter cluster add-node node-serial="node_serial".
• B. Use Prism Element to Expand the cluster and select the re-image option.
• C. Upgrade the cluster to 5.9 and add the node through Prism Element.
• D. Use Prism Element, which will downgrade the node by default during the node add process.

Answer: B

 

NEW QUESTION 115
An organization is planning an upgrade to AOS 5.15 and wants to understand which cluster products and/or services are supported for physical traffic isolation.
Which Nutanix component supports its network traffic being isolated onto its own virtual network?

• A. Containers
• B. Volumes
• C. Files
• D. Objects

Answer: B

 

NEW QUESTION 116
An administrator needs to install prism central for their 2550 multi-cluster environment.
How should they deploy the application?

• A. Deploy a large 1-VM Prism Centralinstance.
• B. Deploy a small 3-VM Prism Central instance.
• C. Deploy a small 1-VM Prism Central instance.
• D. Deploy a large 3-VM Prism Central instance

Answer: D

 

NEW QUESTION 117
After uploading a hypervisor ISO during the Foundation process, a consultant sees a message that the MD5 sum for the hypervisor is not found in the Whitelist file.
Which step should the consultant take next to resolve this issue?

• A. Restart the Foundation process and upload the hypervisor again.
• B. Check the hypervisor version in the Nutanix Compatibility Matrix.
• C. Download the hypervisor ISO again from the vendor website.
• D. Download the latest hypervisor ISO whitelist file from Nutanix portal.

Answer: D

 

NEW QUESTION 118
A customer is running out of storage in an ESXi cluster. The customer wants to add storage without paying for an additional hypervisor license.
Which option should the consultant recommend to meet the requirement?

• A. Buy a new node to meet the requirements of the storage-only node specifications.
• B. Select the storage-only checkbox during Foundation and then expand the cluster in Prism.
• C. Convert the cluster to AHV to support storage-only node requirements.
• D. Edit the factory_config.json file to configure the node as storage-only and then expand the cluster in Prism

Answer: A

 

NEW QUESTION 119
An administrator of a Nutanix Enterprise Cloud has microsegmentation enabled and a firewall VM installed.
The security team notifies the administrator that one of the VMs hosted in the environment has been exhibiting suspect network activity. The administrator wants to isolate the VM from the production network, but must still be able to access it to perform diagnostics.
What should the administrator do to meet the requirement?

• A. Quarantine the VM using the Forensic Method
• B. Disable the vNIC on the affected VM
• C. Create asecurity policy with a service chain directing that VMs traffic to the firewall VM
• D. Create a firewall rule that blocks VM traffic but permits diagnostic access

Answer: A

Explanation:
Explanation
Refhttps://portal.nutanix.com/page/documents/kbs/details?targetId=kA00e000000LIelCAG

 

NEW QUESTION 120
An administrator deletes a large amount of data from a Volume Group presented to a Linux VM. The administrator notices that the deleted data has not been reclaimed as usable storage.
Whataction should be taken to reclaim the storage capacity?

• A. Enable the unman operation on the Linux VM
• B. Unmount the Volume Group and then Remount the Volume Group
• C. Run Defrag on the Linux VM
• D. Shrink the Volume Group that is associated with the Linux VM

Answer: B

Explanation:
Explanation
https://next.nutanix.com/how-it-works-22/vm-capacity-and-prism-capacity-are-different-33134

 

NEW QUESTION 121
What reference materials should be provided to the customer during the Knowledge Transfer?

• A. Questionnaire, technical slides and checklist, links to documentation and resources
• B. As-Built Guide, Project Plan, links to documentation and resources
• C. As-Built Guide, technical slides and checklist, Network Diagram
• D. As-Built Guide, technical slides and checklist, links to documentation and resources

Answer: D

 

NEW QUESTION 122
A customer with a four-node RF2 cluster is addingapplication VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?

• A. The customer has the ability to add more VMs up to the 100% storage utilization.
• B. The cluster is not resilient in the storage fabric
• C. Node failure is imminent due to storage utilization.
• D. There is available capacity in the storage fabric and the cluster is resilient.

Answer: B

Explanation:
Explanation
https://next.nutanix.com/how-it-works-22/recommended-maximum-storage-utilization-37234

 

NEW QUESTION 123
An administrator is configuring an All Flash cluster to support the following workloads:
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Whichthree correct configuration options should the administrator use to meet the item requirements? (Choose three.) For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.

Answer:

Explanation:

Explanation

Ref:

 

NEW QUESTION 124
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?

• A. An Application Security Policy
• B. A Quarantine Policy
• C. AnIsolation Environment Policy
• D. A Whitehst-Based Policy

Answer: C

Explanation:

 

NEW QUESTION 125
An administrator learns that some security settings in a cluster have been changed. The environment is out ofcompliance with required policies.
Which function should be used to revert any settings that have changed from the defaults and prevent further violations?

• A. Defense Information Systems Agency STIG enforcement
• B. Advanced Intrusion Detection Environment (AIDE)
• C. Cluster Lockdown with strong password enforcement
• D. Security Configuration Management Automation (SCMA)

Answer: D

Explanation:
Explanation
Ref:http://myvirtualcloud.net/nutanix-scma-the-security-feature-that-could-save-your-organization/

 

NEW QUESTION 126
Anadministrator recently added VLAN 205 CRM in Prism Element. The workloads attached to the associated NICs are unable to establish network connectivity.
Which Layer 2 protocol allows the administrator to troubleshoot this issue from Prism Element?

• A. HDLC
• B. SUP
• C. LACP
• D. LLDP

Answer: D

Explanation:

 

NEW QUESTION 127
A consultant creates three storage containers (container-1, container-2, container-3). The customer requires that only container-1, which will be utilized as an NFS datastore, be presented to external hosts.
However, users are able to mount all three containers.
What is causing this problem?

• A. Deduplication was turned on for all containers.
• B. A Global whitelist entry was configured.
• C. A Container-level whitelist entry was configured.
• D. Compression was turned on for all containers.

Answer: B

 

NEW QUESTION 128
Refer to the exhibit.

What is the purpose of eth2 on the CVMs?

• A. Network Segmentation
• B. iSCSI connectivity
• C. Remote site connectivity
• D. RDMA Network Segmentation

Answer: A

Explanation:
Explanation
Ref:https://next.nutanix.com/installation-configuration-23/backplane-network-in-aos-5-5-27291

 

NEW QUESTION 129
A Nutanix cluster is deployed with the following configuration:
* Three four-nodeblocks (A, B, and C)
* All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?

• A. VMs on the nodes with failed disks are unable to write data
• B. Each node with a failed disk is marked as degraded.
• C. VMs are migrated off of the nodes with disk failures.
• D. VM read and write operations continue normally.

Answer: D

Explanation:
Explanation
Ref:https://next.nutanix.com/how-it-works-22/redundancy-factor-vs-replication-factor-37486

 

NEW QUESTION 130
......

Nutanix Certified Services Core Infrastructure Professional Practice Tests 2023 | Pass NCS-Core with confidence!: https://drive.google.com/open?id=1LbJ_5NdVDf63f7CEBh5p0tQn57bK1oEd

Online Exam Practice Tests with detailed explanations!: https://www.dumptorrent.com/NCS-Core-braindumps-torrent.html